Foundry Magazine
Foundry Channels
  METALS & ALLOYS   MELTING   REFRACTORIES   SAND & BINDERS   POURING & FILTERING   COREMAKING   MOLDING   SIMULATION   AUTOMATION   PROCESS CONTROL   SHAKEOUT, CLEANING,
  & FINISHING
  HEAT TREATING   TESTING, MEASURING,
  & QUALITY CONTROL
  ENVIRONMENT, HEALTH,
  & SAFETY
CASE STUDIES USEFUL LINKS SUBSCRIPTIONS CONTACT US
 
Refractories
Foundry Channel Products
To Subscribe to the RSS Feed
Results : 1 - 14 of 14
New Controller for Rotary Screw Air Compressor
02/01/12
More convenient control capability and reliable monitoring system optimize plant efficiency.
High-Capacity, Hydrostatic Batch Mixer
11/01/11
The Pan Mixer is designed for safe and easy operation, with a control panel for mixing and material discharge operations on a large operator platform. The bottom...
Energy-Efficient Heat-of-Compression Dryers
11/01/11
Alternative to desiccant dryers deliver clean, dry air using waste heat from the air compressor
High-Temperature Fiber-Based Insulating Material
09/01/11
A representation of the insulating properties of Superwool® 607® HT™. Do not attempt to recreate this or any simi...
Shotcrete Pump for Refractory Installation
08/01/11
Blastcrete’s X-10 is a 3-in., swing tube pump capable of delivering up to 12 cub...
High-Performance Insulation with Less Mass
05/01/11
Maximized fiber content means low thermal conductivity, energy savings, better handling
Precision Gunning Machine is Effective, Easy to Operate
01/01/11
The AA020 Piccola rotary gunite machine from Blastcrete Equipment Co.
Insulation Wool Delivers Higher Performance with Less Mass
12/01/10
The new MORGAN THERMAL CERAMICS Superwool Plus high-temperature insulation wool is 17 percent more energy-efficient than traditional refractory ceramic fiber (RCF), the...
Biosoluable Insulation
07/01/08
THERMAL CERAMICS' Superwool Plus retains the advantage of exoneration from any carcinogen classification enjoyed by the standard Superwool 607, but has 30% more superior...
Ultra-Low Water Castable Refractories
02/01/07
ALLIED MINERAL PRODUCTS' V-CAST 700 series castables are a line of ultra-low water castables, designed for molten iron contact areas in channel furnaces, cupolas,...
Moldable Refractory
11/01/06
THERMAL CERAMICS Superfil 607 Moldable is a wet mastic material good for continuous use up to 2,000°F, with minimal shrinkage and high strength, even at high ...
Quick-Change Laminated Discs
11/01/06
ALLIED MINERALS line of Tuff-crete refractory products are low-cement castables specifically designed to be installed by shot-creting, but also can be pumped,...
Thermal Shock-Resistant Silica Composite
11/01/06
ZIRCAR REFRACTORY COMPOSITES refractory sheet type RSLE-57 is a low thermal expansion, high-strength reinforced silica matrix composite. Designed for use as a...